Tuesday 2 January 2018

A Palm Grove

Part of my holiday reading has been Juan Cole's "Napoleon's Egypt: Invading the Middle East". As I was reading the chapter describing the march from Alexandria to Cairo I found some first hand descriptions of the local villages. Two passages captured my imagination.

The first passage reads; "...Rahmaniya...a village where the typical dwelling consisted of 'a hut, the walls of which are made of earth or sometimes sun-baked bricks, four feet high. The size is proportional to the family. One can only enter hunched down—one cannot get in standing up straight. Typically there is a pretty structure above, gracefully constructed, serving as home to a great quantity of pigeons.'" This provides the inspiration for some upcoming buildings, although just how I am going to make a building that has only four feet of wall height not look a bit comical I don't yet know.

The second passage reads; “Next to every village in Egypt, there is a date grove, trees of very great revenue (each date tree generates about seven francs per year). These groves are more or less extensive, depending on the population and wealth of the villages. They make for most agreeable scenery." Now this was a simple project for me.

I chose to make my grove about 150 mm square with nine palms. Using a jigsaw I cut an irregular shape from some hardboard. Then I cut a slightly smaller piece, glued them together and put them under a heavy weight until the glue set.



When I removed the weight I found that the two pieces has slipped a little - the result if putting too much glue on the surfaces and not spreading it! The result was that the sheets had come too close in one edge. So to conceal this I chose to put a stack of stones there. So I mixed up some quick set epoxy putty, pressed it around the affected edge an then pressed some small gravel into the putty. 


The putty took about five minutes to set then I drilled the holes for all the palms and fixed the first four palms by putting a blob of rapid set epoxy putty under each one and then pressing it tight around the base of the tree.


When this putty was set I applied the first batch of base cover. This had to be done at this point because once all the palms are in place it would be impossible to get a palette knife some of the areas of the base.


Next I added the rest of the palms using the same putty technique as above and when the putty was set, applied the final coat of texture paste. 


A coat of sand coloured paint, a wash of thinned down Games Workshop Seraphim Sepia, a light dry brush of white and a few grass tufts and it was done.







14 comments:

  1. Effective and splendid job!

    ReplyDelete
  2. Nice work! Your time spent on Fiji was not a waste!

    ReplyDelete
    Replies
    1. I concur, the research in Fiji was well worth the effort. Back to work and back to reality with a bang today.

      Delete
  3. Replies
    1. Thanks Mark. It is such a simple model, but looks so effective. I can hardly wait until I finish the project and get the armies (and the terrain items) on the table.

      Delete
  4. Great work again Mark. This afternoon I have yet again put out two wheelie bins full of Alexander palm fronds so it is difficult for me to look at a palm tree without flinching, but these look spectacular.

    ReplyDelete
    Replies
    1. Thanks Lawrence. We too did battle with palms - Phoenix palms in our case...with nasty spikes - trimming the dead fronds off four of them and cutting one out that was blocking light into the living room. It was hard work on a hot day, but very satisfying...and I got to play with the chainsaw!

      Delete
  5. So...
    We have the pool and now the palms...
    A we need is a model of you sipping a cold beer.... ;-)

    Lovely stuff...

    All the best. Aly

    ReplyDelete
    Replies
    1. ...and a man to serve that beer of course! But that, and all of the other delightful poolside sights, is all a distant memory now...back to work today and back to reality with a thump.

      Delete
  6. Lovely looking grove and thanks for the interesting WIPs.
    Best Iain

    ReplyDelete
    Replies
    1. Thanks Ian. It is still sitting on my desk and I am really pleasd with it...just need to get it on a table!

      Delete